| Post 1 made on Wednesday May 30, 2001 at 23:54 |
I just purchased RCA Universal Remote Control (RCU500). I found the codes for the TV and VCR with no problem. But for some reason, when I hit the "Menu" button to program the VCR (an older Signature 2000) to record a show, nothing comes up. No blue screen to program the VCR---nothing.
Can someone tell me if it's possible to use the RCA Universal to program the VCR or should I take the remote back to the store?
Thanks!
|
|
| OP | Post 2 made on Thursday May 31, 2001 at 08:49 |
Mike Riley Historic Forum Post |
|
|
One command that is often lacking form URCs is the Timer Record. Unless your new remote is also a learning remote (which I don't think it is), you will not be able to do that kind of VCR recording, because the Device code doesn't have it built in to the set of commands. (Although it may have been applied to a different button... check them all; also, sometimes a different Device code for the same brand of TV will have the command... try another.)
A learning remote like the Radio Shack RS-1994 can do it for you... ... Mike
|
|
| OP | Post 3 made on Saturday June 2, 2001 at 22:52 |
ihave a systemlink4 remote i need code for a zenith and how to put in t
hanks
|
|
| OP | Post 4 made on Wednesday June 6, 2001 at 16:41 |
herman bentley Historic Forum Post |
|
|
my tv is a orion but,there is no code on my rca remonte
how would i go by finding that code
|
|
| OP | Post 5 made on Wednesday June 6, 2001 at 20:32 |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
