| Post 1 made on Sunday September 18, 2005 at 17:21 |
Vikerex Long Time Member |
Joined:
Posts: | December 2004
23 |
|
|
I seem to be having a problem with the software? When I try to program an IR code I get the following message:
Data source name not found and no default driver specified.
Then it goes into the learning mode, and after it learns the code, and I hit ok, I get:
An unsupported operation was attempted.
Then when I look at the actions screen I see:
Learnt Code, instead of learned code.
????
|
|
| Post 2 made on Sunday September 18, 2005 at 19:35 |
Lyndel McGee RC Moderator |
Joined:
Posts: | August 2001
12,910 |
|
|
Which version of the software? They just released a new version. Can you please indicate which version you are using obtained from the About Box???
|
Lyndel McGee
Philips Pronto Addict/Beta Tester
|
|
| Post 3 made on Sunday September 18, 2005 at 20:01 |
Lyndel McGee RC Moderator |
Joined:
Posts: | August 2001
12,910 |
|
|
If you've just installed the software, ensure that you reboot the PC.
Also, please ensure that you installed the software under a user account with Administrator Rights.
|
Lyndel McGee
Philips Pronto Addict/Beta Tester
|
|
| OP | Post 4 made on Monday September 19, 2005 at 05:55 |
Vikerex Long Time Member |
Joined:
Posts: | December 2004
23 |
|
|
I just installed the new edit software, no problem now.
Thanks
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
