| Post 1 made on Thursday September 15, 2005 at 13:45 |
pmsyb Lurking Member |
Joined:
Posts: | September 2005
2 |
|
|
A newbie here and this is a fantastic site.I have a remote projection screen and is to long for my space and cant be programmed to automatically stop.There is a stop button on it i use so it wont unravel the whole way.I search for an answer but found none.Is there a way I can run a macro to tell it to stop after a certain amount of time.Thanks for any inputs.
|
Matt |
|
| Post 2 made on Thursday September 15, 2005 at 17:29 |
Peter Dewildt Loyal Member |
Joined:
Posts: | July 2001
6,307 |
|
|
I don't fully understand what you are saying. However, you can adjust the Duration of an IR Code to specify how long it transmits.
|
Peter
Pronto 1000 (retired), Pronto TSU7000, RFX6000 (retired)
Pronto 2xTSU9600, RFX9400 |
|
| OP | Post 3 made on Thursday September 15, 2005 at 18:38 |
pmsyb Lurking Member |
Joined:
Posts: | September 2005
2 |
|
|
There is no way to preset the stop, unless you press the stop button.Otherwise it will open the whole way,and i dont need the last 18".So I would send a code to open it,then have it send anther code after so many seconds.If so How do i go about that.
|
Matt |
|
| Post 4 made on Thursday September 15, 2005 at 21:30 |
jcl Advanced Member |
Joined:
Posts: | January 2003
997 |
|
|
Simply create a macro with your down command, a delay of the appropriate time for the screen to lower and then the stop command. For info on creating a macro see the Frequently Asked Questions.
|
Jon
Too many toys, too little time. |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
