| Post 1 made on Friday January 7, 2005 at 08:37 |
pesto Founding Member |
Joined:
Posts: | November 2001
14 |
|
|
This may be a very simplistic problem however, I am unable to solve it. I have successfully customized all of my lower TSU3000 hard buttons (i.e. OK, Home, Up, etc.) except the "TOGGLE" button. I have read all available information from this site to no avail. In the FAQ it states: "Using the latest firmware and software, everything except for the Page Up/Down and Backlight buttons can be customized". I have linked codes to this button and it continues to operate as the pre-programmed toggle. What am I doing wrong?
|
|
| Post 2 made on Friday January 7, 2005 at 11:23 |
Mike Morgan Long Time Member |
|
|
Yesterday was my first day programming my new Pronto NG. You have to go into the setup on the remote and turn Cursor Navigation to Off. Then the Toggle button is freely programmable. Hope that helps.
Mike
|
|
| OP | Post 3 made on Friday January 7, 2005 at 11:44 |
pesto Founding Member |
Joined:
Posts: | November 2001
14 |
|
|
Thanks for that tip. I obviously missed that important note in the information. I will try it this evening!
Tom
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
