Hello again guys, it's been quite some time since I've been here to the site. I have a Pronto 2000 and I'm upgrading to the NG 3000 that will be delivered tomorrow.

Now for my question... I'm sorry, I tried searching and found a thread asking the same exact question I have, but there was no resolution.

I downloaded PENG 2.0.9 a little while ago and installed it on my desktop running XP Pro. Install went fine and I can create new files and even import old CCFs that I have. I have downloaded a few NG CCFs from the Files area and I can not open them in PENG. I have double-clicked them from their location, and tried opening from within PENG. I get the error "This file type cannot be opened by this editor." I extracted the files and their properties indicate that they are ProntoEdit NG Configuration files and open with PENG.

You guys have any suggestions on how I can get these things to open? The file translator in the Files section is only for opening PENG files in PPENG, correct? Thanks RC!

Mike

I really feel stupid now. Please disregard my post. An admin may remove this thread if they desire. The first two PCFs I was trying to open were PPENG PCFs. PENG downloaded from the site work fine.

The dummy - Mike :)

No problem, Mike. It is a bit more complex than it was in the 2000 days. No worries, bud!

Dave D'Arche