| Post 1 made on Monday December 20, 2004 at 20:40 |
DoctorO Long Time Member |
Joined:
Posts: | January 2004
18 |
|
|
Even having downloaded the Anthem codes for pronto from their website, and installed the newest firmware and editor for the 7000, I am having a terrible time getting codes to work. Worst of all are the adjustments for Surround Modes. They are a three step code, the Mode button followed by two digits. The mode and the first digit enter without difficulty. I cannot get the third digit to enter, using delays from .1 to 1.5 in desparate trials. What is going on here?? Any workaround? And is there any way to get the daggone Setup button to work using a repeating code?
Thanks!!!
|
|
| Post 2 made on Monday December 20, 2004 at 21:37 |
Peter Dewildt Loyal Member |
Joined:
Posts: | July 2001
6,307 |
|
|
I assume you are trying:
- link to Mode
- delay
- link to first digit
- delay
- link to second digit
Try very long delays just to get it working. Then reduce the delays as much as you can.
If the codes are a problem, check that they are not dirty (they shoudl all look similar).
|
Peter
Pronto 1000 (retired), Pronto TSU7000, RFX6000 (retired)
Pronto 2xTSU9600, RFX9400 |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
