| Post 1 made on Wednesday December 15, 2004 at 19:35 |
Is anyone out there successfully feeding a Xantech RT-8 from an RFX-6000?
I've got the RFX-6000 going into the 'High Out' port on a Xantech 791-44 connecting block (as recommended here on RemoteCentral), which works great for the Xantech emitters connected to the block. For whatever reason, the RT-8 fails to acknowledge any of the IR signals getting passed to it.
Any advice would be appreciated...
|
|
| Post 2 made on Wednesday December 15, 2004 at 22:11 |
roddymcg Loyal Member |
Joined:
Posts: | September 2003
6,796 |
|
|
Are you using any delays?? I have had many issues using the Pronto RF, so you might want to also try taking that out of the mix and check it just using IR. None of my issues with the RFX-6000 have been RT-8 related though, I have not had much luck controlling Pioneer Elite product.
None the less, try adjusting the delays so the RT-8 goes to the right output before the device signal goes on through it. I usally have a minimum of .2 second delays when using the RT-8.
Good luck,
|
When good enough is not good enough. |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
