| Post 1 made on Wednesday December 15, 2004 at 12:11 |
ckinard Lurking Member |
Joined:
Posts: | December 2004
5 |
|
|
Many times when i place bitmaps on my pronto (copied from someone else's layout), the bitmap,such as a button, will appear dimmed like it has a translucent setting. But it doesn't...if i click it the pressed state will work, but then go back to the messed up released state. Anyone know the problem? It's happened quite a lot.
|
-Kinard |
|
| Post 2 made on Wednesday December 15, 2004 at 12:51 |
wizman44 Long Time Member |
Joined:
Posts: | September 2004
10 |
|
|
The button has to have an action on it. Whether it be an IR code, delay, link, etc. Otherwise it appears grayed out. Try just putting a delay on one and you will se how it changes.
|
|
| OP | Post 3 made on Wednesday December 15, 2004 at 13:01 |
ckinard Lurking Member |
Joined:
Posts: | December 2004
5 |
|
|
thanks man, i knew it had to be something stupid like that.
|
-Kinard |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
