Hi :-)

I received my TSU3000 two days ago and have a question I hope one of you is able to answer :-)

I have a Grundig Xentia TV with 5 AV channels (4 AV and 1 VGA). On the original remote the only way to switch between these AV channels is by using the 0/AV button.

Are there any codes available to select one of these AV channels with one code without cycling through all AV channels? I would like 5 buttons on my remote, one for each AV channel. I have tried to make a macro that first go to channel 1 and then AV1 (using the 0/AV code) and then AV2 etc. The problem is that if I am using for example AV3 and go to channel 1 and push the 0/TV button I return to AV3 channel. I always return to the last used AV channel, this makes it difficult to make a macro to select one specific AV channel.

Thanks :-)

Best Regards,
Jarle

Hi again :-)

I have found a solution to this. I had to make a some macros that are as follow:

To select AV3 on the TV:
Press 1 (to have the a starting-point)
Press ch- (to go to AV5)
Press 0 (to go to AV1)
Press 0 (to go to AV2)
Press 0 (to go to AV3)

To select AV2 on the TV:
Press 1 (to have the a starting-point)
Press ch- (to go to AV5)
Press 0 (to go to AV1)
Press 0 (to go to AV2)

To select AV1 on the TV:
Press 1 (to have the a starting-point)
Press ch- (to go to AV5)
Press 0 (to go to AV1)

I have to go via channel 1 and AV5 to get the correct starting point.

These macros are not perfect they are working about 80% of the time.

Best Reards,
Jarle