| Post 1 made on Sunday December 10, 2000 at 11:40 |
Troy Madlem Historic Forum Post |
|
|
I've looked everywhere and tried everything I can think of to get my new Dish Network 6000 receiver to accept the IR codes from my Pronto. I've downloaded several ccfs for the 6000 with the IR codes but none of them will work. What setting on the 6000 might be wrong that keeps it from recognizing the IR commands? Is there something to change in a service menu?
Thanks for any pointers. This is getting VERY frustrating.
Troy
|
|
| OP | Post 2 made on Sunday December 10, 2000 at 21:43 |
Daniel Tonks Historic Forum Post |
|
|
It should be in the normal menus, but does that receiver have a setting for IR/RF?
|
|
| OP | Post 3 made on Sunday December 10, 2000 at 21:47 |
Some DISH models have a switch in the back next to the UHF atenna to change it to IR, some have it in the set-up menu
Hope that helps.
|
|
| OP | Post 4 made on Monday December 11, 2000 at 19:03 |
Troy Madlem Historic Forum Post |
|
|
Thanks for the suggestions. I found the receiver needed to be on remote address 1 for the IR functionality to work.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
