| Post 1 made on Tuesday November 28, 2000 at 22:34 |
Eric Smith Historic Forum Post |
|
|
I use my Pronto in my bedroom and just installed a Hunter Ceiling Fan with remote. I have been unable to learn the codes from its remote either directly or through the software. Has anybody else tried this or have access to the codes?
|
|
| OP | Post 2 made on Tuesday November 28, 2000 at 22:40 |
Barry Shaw Historic Forum Post |
|
|
Eric-
Are you sure the remote is IR and not RF? (radio frequency)
If you can control the fan without pointing, without line-of-sight, from under a pillow or blanket (see the "blanket" post for a laugh!)it's RF and you're pronto-toast.
|
|
| OP | Post 3 made on Tuesday November 28, 2000 at 22:48 |
Eric Smith Historic Forum Post |
|
|
I saw the blanket post :)
I think it's IR. It has a little red light on top. I'll try it from under the blanket, bed or body.
|
|
| OP | Post 4 made on Tuesday November 28, 2000 at 22:59 |
it is probably RF and that is why not working. Had the same problem.
G
|
|
| OP | Post 5 made on Tuesday November 28, 2000 at 23:02 |
Eric Smith Historic Forum Post |
|
|
I tried it from another room. Duh. It's RF. What type of remote did you have trouble with? Might there be RF support in a future product?
|
|
| OP | Post 6 made on Tuesday November 28, 2000 at 23:08 |
same type with the fan....would have liked it to control fan in home theater room but ran into same issues....Pronto great remote for all other issues...
g
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
