| Post 1 made on Saturday November 25, 2000 at 20:55 |
Gerard ten Napel Historic Forum Post |
|
|
Can't get the firmware updated, i'm stuck on 4.7 and the update to 5.1 which comes with the software 2.1 doesn't seem to load into the RC. This results in the following: when a new configuration is uploaded, i only have to touch a button and i get the message "configuration file corrupted" the only choice left is "revert". Can someone help me out?
|
|
| OP | Post 2 made on Monday November 27, 2000 at 17:57 |
Theo van Raaij Historic Forum Post |
|
|
Hello Gerard,
Did you choose the correct memory-size?
It's 1MB for Europe.
|
|
| OP | Post 3 made on Tuesday November 28, 2000 at 18:01 |
Gerard,
I had the same problem. The config is corrupted because you may have an offending command, i.e. "back" or "jump" that isn't compatible because you havn't upgraded yet.
Solution:
Break apart your ccf into parts. Save a different ccf for each device. Then start with a master ccf of one of the devices and download that into the pronto. If it takes it without giving you the corrupt error, then merge the next device and re-save the ccf. Then you will be able to isolate which device is causing the offending command.
It's most likely a "back" or "jump" button.
I hope this helps.
-Jon
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
