| Post 1 made on Friday April 23, 1999 at 23:34 |
Amazingly Smooth Historic Forum Post |
|
|
I want to know if the Pronto has variables. I would like it to remember the last station it was on and if the CH+ button gets to a certain point I want a macro enabled. Basically, what I want to do is switch between my cable box and my satellite box using the CH+/- button when I get to the last/first station on the device (cable or SAT). Any thoughts?
|
|
| OP | Post 2 made on Friday April 23, 1999 at 23:42 |
Daniel Tonks Historic Forum Post |
|
|
No, there's no automatic way to do something like that with the Pronto. That's getting too much into actual "programming", which can't be done on the Pronto. This is after all just a remote control! :-)
|
|
| OP | Post 3 made on Sunday April 25, 1999 at 02:18 |
paul V Historic Forum Post |
|
|
Hmmmmm. Well, If all you are doing is surfing, I suppose you could use a macro to go from channel to channel with some delay between commands. Set it up so that when it reads the last channel, it will go to the next device through a jump command.
Paul
|
|
| OP | Post 4 made on Sunday April 25, 1999 at 13:13 |
Amazingly Smooth Historic Forum Post |
|
|
How do I get it to "read the last channel"?
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
