| Post 1 made on Tuesday September 5, 2000 at 18:47 |
Gary S Historic Forum Post |
|
|
I have two questions for the forum,
1. How do I change the delay time in my Pronto? I get the default square but I can't change it.
2. Can the Denon avr3300 tuner codes be used in a macro to directly access a station or only to program the receiver ? It appears that with the Denon remote, I can't directly access stations, I have to scroll, so maybe direct access isn't possible ? Thanks for any input
|
|
| OP | Post 2 made on Tuesday September 5, 2000 at 19:38 |
Peter Dewildt Historic Forum Post |
|
|
1. Double click on the delay and a window pops up.
|
|
| OP | Post 3 made on Wednesday September 6, 2000 at 06:04 |
Gary S Historic Forum Post |
|
|
Peter, how do I change the default once the window pops up? So far, I haven't been able to change it.
|
|
| OP | Post 4 made on Wednesday September 6, 2000 at 10:19 |
Ron Krause Historic Forum Post |
|
|
Hi Gary:
As another new user (4 days), I had the same problem. After you enter the delay, you have to hit the return key! It would of been nice for Phillips to put an "OK" button on the dialog box.
Good luck,
Ron
|
|
| OP | Post 5 made on Wednesday September 6, 2000 at 17:08 |
Daniel Tonks Historic Forum Post |
|
|
You can also set an actual default -- which will be the new automatic value (instead of 0.1 seconds) -- by holding the SHIFT key and pressing the DELAY button. Enter the new number, then hit ENTER.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
