| Post 1 made on Friday September 1, 2000 at 10:46 |
Anthony Historic Forum Post |
|
|
I tried searching the forum for this issue, but I couldn't find it.
I just tried using the jump backward/forward commands and they immediately cause my RC5000 to reset.
My friend's new RC5000i seems to execute these commands without any problem.
Thanks.
|
|
| OP | Post 2 made on Friday September 1, 2000 at 17:27 |
Graham Smith Historic Forum Post |
|
|
You probably need to update the APP version on your RC5000 so that it is version 5.0 or later. To check, go to the config panels. If you are like my RC5000 which I bought yesterday, it is on version 4.x
To update, if you do not already have it, download version 2 of the RC5000 setup software. Under TOOLS there is "Update RC5000". This will bring it up to version 5 for you and fix your problem (well it did for me anyway!)
Good luck
|
|
| OP | Post 3 made on Friday September 1, 2000 at 17:34 |
Daniel Tonks Historic Forum Post |
|
|
There is also a special note on how to get forward/back working properly on the RC5000 Setup download page on this site.
|
|
| OP | Post 4 made on Saturday September 2, 2000 at 01:45 |
Anthony Historic Forum Post |
|
|
I had no idea that I had to update the APP version! I thought the new version of RC5000 Setup did this automatically. It works great now. Thanks for your help.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
