| Post 1 made on Saturday August 26, 2000 at 21:44 |
John McKee Historic Forum Post |
|
|
I just spilled a glass of water on the screen, now all the buttons work, and it beeps when you use the touch screen, but nothing shows up on the screen. Is there anything that can be done to same my pronto?
|
|
| OP | Post 2 made on Saturday August 26, 2000 at 22:02 |
Daniel Tonks Historic Forum Post |
|
|
Generally, let it dry really really well. Running power through it wet could (or could already have) fried a few important things. Take a look at the "sticky" Pronto thread, there's some good tips in there.
|
|
| OP | Post 3 made on Sunday August 27, 2000 at 09:11 |
Tom Held Historic Forum Post |
|
|
Remove the batteries until you're sure it's completely dry. If you want to make sure it dries thoroughly you might endeavor to open the case. Dust-Off and similar "canned air" products can blow droplets out of impossible-to-reach areas where water may linger even after it looks dry.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
