| Post 1 made on Saturday May 27, 2000 at 18:16 |
In Pronto Edit, I have devised a "start up" screen which will lead to all other screens, but I cannot seem to get Pronto Edit to recognize this "start up" screen as the first screen. My virtual Pronto always seems to start with another screen, and I can only get to my "start up" or home screen after using the "home" key. (Which I have programmed to always lead to this "start up" screen.) Any suggestions? The FAQ and Manual and Pronto Edit User Guide don't seem to address this. Thanks.
|
|
| OP | Post 2 made on Saturday May 27, 2000 at 20:22 |
Daniel Tonks Historic Forum Post |
|
|
You can only start up on one of two screens.
1) The very first home panel, or
2) The very first panel of the very first device.
This is described in the Pronto FAQ, section B6-06.
|
|
| OP | Post 3 made on Sunday May 28, 2000 at 00:06 |
James Lenneman Historic Forum Post |
|
|
Since you want to access all other screens from your "start up" screen make it the very first panel under home as Daniel said. If you check the "home panel is write-protected" block under home panel properties it will come up first.
Jim
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
