| Post 1 made on Tuesday May 23, 2000 at 14:04 |
Jose Blanco Historic Forum Post |
|
|
I know you can not program a Marantz RC-5000 with the Prontoedit program...but can you copy a CCF file from your prontoedit folder and paste it in the marantz "edit" folder, open it up with the marantz program? Will it work? Also, I have a ccf (in prontoedit) that I want to merge it with a Marantz ccf file...can this be done?
|
|
| OP | Post 2 made on Tuesday May 23, 2000 at 14:22 |
Cary Gerber Historic Forum Post |
|
|
I believe the ccfs are interchangeable, whereas the editor and firmware are not.
Try searching for Marantz, there were some posts where the differences were discussed between it and the Pronto, and I believe this was covered in parts of the discussion. This might also be in the FAQ.
|
|
| OP | Post 3 made on Tuesday May 23, 2000 at 14:53 |
Jose Blanco Historic Forum Post |
|
|
I just tried this and it worked fine. I also merged and it worked great. Thanks for your response.
|
|
| OP | Post 4 made on Tuesday May 23, 2000 at 15:17 |
Daniel Tonks Historic Forum Post |
|
|
Yes, CCFs are, for all practical purposes, the same between RC5000 Setup v1.02 and ProntoEdit v1.05.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
