| Post 1 made on Tuesday May 16, 2000 at 23:18 |
When I download a ccf to my Pronto (which I just got yesterday), the computer will not recognize the Pronto unless I first tap the screen to wake it up. Is this normal? It is the same on two different computers. If the Pronto is dark, just laying there and I start a download to it, it says "No configuration info found, want to overwrite?" Then if I say yes, it tries and then says "operation failed"...
Thanks
|
|
| OP | Post 2 made on Tuesday May 16, 2000 at 23:38 |
Daniel Tonks Historic Forum Post |
|
|
I wouldn't call it "normal", but it certainly is common. Mine does that about 50% of the time.
|
|
| OP | Post 3 made on Friday May 19, 2000 at 15:22 |
Tom Held Historic Forum Post |
|
|
That must be annoying! It hasn't happened on mine at all. The only time it gives me a hard time is when I forget to plug the cable into the Pronto (about 50% of the time).
Tweeking the COM port might help. You might try a slower speed. Is the COM port being shared with any other devices?
Settings on my COM1:
Baud Rate: 115200
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: Hardware
FIFO: Enabled
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
