| Post 1 made on Saturday February 15, 2003 at 13:14 |
topo Lurking Member |
Joined:
Posts: | February 2003
4 |
|
|
The TS 1000 is now unable to learn from a remote that I used in the past (tivo). I get a "fail" indication. Is there possibly a lock on changing commands?
|
|
| Post 2 made on Saturday February 15, 2003 at 13:49 |
King of typos Loyal Member |
Joined:
Posts: | June 2002
5,265 |
|
|
Is that remote the only remote that it won't learn from?
Or are other remotes not being learned as well?
Also you might want to think about reflashing the firmware.
Rob
|
|
| OP | Post 3 made on Saturday February 15, 2003 at 14:13 |
topo Lurking Member |
Joined:
Posts: | February 2003
4 |
|
|
Rob, It won't learn with any remote. However I can add and delete a device, so I don't think the programming is locked.
|
|
| Post 4 made on Saturday February 15, 2003 at 14:22 |
King of typos Loyal Member |
Joined:
Posts: | June 2002
5,265 |
|
|
Are you pointing the remotes at the correct place on the pronto? Remember the learning eye of the pronto is at the buttom end.
How are the batteries in all the remotes?
Are you learning the ir codes on the remote directly? Or with in the pc based software? Most people find it better to learn the codes on the remote directly. Rather than using the software as well.
Rob
|
|
| OP | Post 5 made on Saturday February 15, 2003 at 15:01 |
topo Lurking Member |
Joined:
Posts: | February 2003
4 |
|
|
Rob, Thank you so much, I was thinking about everything except where the learning eye was!!!! Now it works fine!
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
