| Post 1 made on Tuesday November 12, 2002 at 11:31 |
Dean Williams Lurking Member |
Joined:
Posts: | November 2002
4 |
|
|
After having installed an ir extender for the TSU6000, all of my ir emitters were blinking intermitently. After reading through the manual I changed the channel of the extender and reprogrammed. The emitters did not blink. However when I installed a second rf extender the new one and its emitters, set to the same channels as the original extender, were blinking while the original extender and its emitters were not. I don't buy the whole RF interference bit in this case...has anyone out there seen this anywhere? Any suggestions on troubleshooting would be helpful too.
|
|
| Post 2 made on Tuesday November 12, 2002 at 16:34 |
Dave Houston RF Expert |
Joined:
Posts: | October 2001
1,521 |
|
|
I think 'channel' is misleading. All of the extenders use the same RF frequency. The 'channel' is probably just an ID byte that is sent as a prefix to the code that tells all of the extenders which one should repeat it as IR.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
