I'm having problems figuring out how to get certain keys programmed that are repeatable, ie, on the remote(dish network) when you press and hold the cursor keys, it keeps on sending a signal to scroll through the guide. Is this possible to replicate on a prontopro?

Thanks,

ken

yes it is. However, it depends on how you learned it. If it a very clean code, or not so clean but not dirty enough not to work. Try relearning the code.
Go to learn mode on the pro.
Press the button on the pro that you want to learn an ir code. Let go of it as soon as you press it.
On the oem remote, point the head of the remote towards the rear end of the pro, about 8 inches away.
Press and HOLD the button to be learned. You may let go when the pro "beeps" You can when it says "ok" on the screen. But I personaly wait til it beeps. Which is about a second later.

Now also, there must be NO other commands in that button. No delay, no other ir code, no jump. Nothing but the ir code that you just learned. For this you must use PE to delete any unwanted command.

Rob