| Post 1 made on Friday October 18, 2002 at 10:54 |
Shane Furlong Lurking Member |
Joined:
Posts: | October 2002
4 |
|
|
I downloaded a CCF file for my Sharp projector and merged it into my configuration. This all seemed to go fine. I followed the same procedure for one for my Cable Box as well. I then changed the Jump Action of the Projector button to correspond to the first panel from the Projector CCF but when you click on the Projector button the page is blank. If you switch to Label mode from Use mode you see the buttons but they don't display regularly. The Cable one I did worked fine. Any ideas?
|
|
| Post 2 made on Friday October 18, 2002 at 11:08 |
bomberjim Super Member |
Joined:
Posts: | September 2001
3,894 |
|
|
Shane, You need an action on a button for it to show up in "normal" mode. Add a .1 delay and they'll appear. Jim L 
|
Jim L  |
|
| Post 3 made on Friday October 18, 2002 at 11:13 |
Anthony Ultimate Member |
Joined:
Posts: | May 2001
28,798 |
|
|
This is a simple problem, you probably deleted the IR codes when you deleted the stuff in the CCF.
go back to the original CCF for the sharp. go to one of the buttons and dblclk it and then press on actions. You will probably see something like X-Y-Z
look in the device/macro tree for X and then look for panel Y. move that panel under the same device as the projectors panel that you want to use. Then do what you did before.
|
... |
|
| OP | Post 4 made on Friday October 18, 2002 at 14:19 |
Shane Furlong Lurking Member |
Joined:
Posts: | October 2002
4 |
|
|
Both of these were helpful. Thanks. I needed to teach it the codes and the delay showed the buttons.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
