i've got a request... i've been trying to get a press and hold button programmed for a new dlp runco projector. i've tried the tips on this website for trying to capture the codes, but with no luck. i've talked to runco support and they've said that issuing the command 4-5 times in a row would work, but it didn't. here are the codes:
On:
0000 006e 0022 0002 0158 00ad 0017 0015 0017 0015 0017 0015 0017 0015 0017 0016 0016 0043 0016 0016 0016 0016 0016 0043 0017 0043 0016 0043 0016 0043 0017 0042 0017 0016 0016 0043 0016 0043 0016 0016 0016 0016 0016 0016 0016 0016 0016 0016 0016 0016 0016 0016 0016 0016 0017 0043 0016 0043 0016 0043 0017 0043 0016 0043 0016 0043 0017 0043 0016 0040 0015 05a3 0158 0056 0016 0e49
Off:
0000 006e 0022 0002 0157 00ae 0016 0016 0016 0016 0016 0016 0016 0016 0016 0016 0017 0042 0017 0015 0017 0016 0016 0043 0016 0043 0017 0043 0016 0043 0016 0043 0016 0016 0017 0043 0016 0043 0016 0043 0016 0016 0017 0042 0017 0015 0017 0015 0017 0016 0016 0043 0016 0016 0016 0016 0016 0043 0016 0016 0017 0043 0016 0043 0016 0043 0016 0016 0017 003f 0016 05a3 0157 0057 0015 0e4a
i know i'm asking for a lot, but this is the best place to go with these problems. thanks to all that at least took the time to read this! if you get somthing that might work, send it to
[email protected]. thanks again!
