| Post 1 made on Sunday June 2, 2002 at 19:31 |
I have a TS1000 and use Prontoedit version 4.0.3. When trying to update the firmware, I select the correct Pronto model, however when the instructions call for hitting the reset on the back of the unit, the progress bar stops and I get a message that says "Could not get information of your boot segment". The unit then reboots to the old firmware version. Any ideas on how to get a proper firmaware update would be greatly apprecaited.
|
|
| Post 2 made on Sunday June 2, 2002 at 19:44 |
Peter Dewildt Loyal Member |
Joined:
Posts: | July 2001
6,307 |
|
|
Some people are having more success by doing the update in PE 1.05.
You should also check what firmware version you already have, as it is more than likely to be already up to date.
Also, I have never been asked to do a Reset. Not sure why it is doing that.
This message was edited by Peter Dewildt on 06/02/02 19:45.45.
|
Peter
Pronto 1000 (retired), Pronto TSU7000, RFX6000 (retired)
Pronto 2xTSU9600, RFX9400 |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
