| Post 1 made on Sunday May 26, 2002 at 17:48 |
Is there any way of finding out exactly why uploading to the PC has failed? I can download *any* CCF file to the pronto and it works fine, but if I try to upload I always get "Error uploading configuration from RC device".
The pronto (940) is active, only 90% of memory is in use.
I've also tried resetting, changing the batteries. In desperation I was going to revert to the orignal configuration but the Revert button is disabled (!)
Anyone know how to do a full reset, or how long the config is retained without batteries?
|
|
| Post 2 made on Sunday May 26, 2002 at 17:50 |
kabster Founding Member |
Joined:
Posts: | July 2001
1,606 |
|
|
forever ring a bell ?
Look in the faq or do a search for "revert"
|
|
| Post 3 made on Sunday May 26, 2002 at 18:51 |
Peter Dewildt Loyal Member |
Joined:
Posts: | July 2001
6,307 |
|
|
The Revert button is disabled until you make any change directly on your Pronto. [The rationale is why revert if you haven't made changes; except that the CCF you revert to is usually the factory default, not your downloaded CCF].
Which version of ProntoEdit are you using? You should try both PE1.05 and PE4.
|
Peter
Pronto 1000 (retired), Pronto TSU7000, RFX6000 (retired)
Pronto 2xTSU9600, RFX9400 |
|
| OP | Post 4 made on Monday May 27, 2002 at 02:39 |
cute reply and point taken about the faq, but the revert issue was more of an aside.
the main problem with uploading was resolved by reflashing the pronto
thx all the same
paul
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
