| Post 1 made on Monday February 11, 2002 at 21:15 |
eicas Founding Member |
Joined:
Posts: | February 2002
13 |
|
|
Hi all,
My vol hard buttons work ok under TV and Receiver when each device is active. But I tryed to learn the vol so that the receiver vol would work when say the Satelite device is active and I get the OK as if it learned it but will not work. Same thing happens when I try to program the vol to any other key in the screen itself. Now if I cut and paste the already programmed button using Pronto Eddit then the button works ok. (the button with the preset programming that Pronto brings)
Does any one have an idea of what could I be doing wrong ?
Thanks for any input.
|
|
| Post 2 made on Monday February 11, 2002 at 22:07 |
Peter Dewildt Loyal Member |
Joined:
Posts: | July 2001
6,307 |
|
|
You should be putting the volume stuff under System Properties. Then the codes work everywhere (except for any device that also has the button programmed under Device Properties - this overrides the system programming).
|
Peter
Pronto 1000 (retired), Pronto TSU7000, RFX6000 (retired)
Pronto 2xTSU9600, RFX9400 |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
