This has me stumped. From my home panel when I am on another device and change to TV the remote sends code out that shuts my TV off. I have discrete codes for on and off but when going to TV it toggles either way if the TV is on or off? The TV button is a jump to my TV page 1. I have looked through all the buttons and can't figure this out?

ECHOSLOB,

It sounds to me like at least one of your TV power codes (both on and off)are not a discreet codes. I'd check that out first. If they are discreet, next step would be a close examination of the macros involved. Lastly, did you check to see if maybe you have a toggle power code loaded on your TV's device properties action list?

Jim L

You ain't found it on a Button, 'cause it ain't ON a Button ! ! !

Look on your TV's Device Properties > Action Tab, there you will find a TV Power Action put there by Philips for the consternation of anyone using the UDB Codes.

It's a common problem, that stumps many newbies.


MIKE
(ps; It's In The FAQs)!

Mike I must be losing it. I actually thought it might be something like that but I think I tried to double click on the udb thingie and nothing happened so I overlooked it. I also looked in the FAQ first and couldn't find anything I promise :)

Strange that this only affected the TV I would think it would do it to the other devices I picked out of the UDB. I am finding I have to tweak or fix a lot of codes I get from the UDB as well. For instance the default off for the TV turned the CD on :) All fixed so far and thanks for the help.

[Link: remotecentral.com]

A3-08 I've got a TSU2000. Why does my TV keep turning off?
When using the TSU2000's built-in database, the default configuration assigns certain functions to automatically transmit each time the device is selected. For some devices this is merely an "input" command, but in the case of the TV template it sends the "power" code. While it's possible to not send the command while switching from one device to another with the Device Menu (by holding down the left or right hard button as you select the device), that can't be done from the Home Menu.
There are two ways to fix this. On the basic remote, without ProntoEdit:


Open the Mode Menu and select "DEL" mode.
Open the device menu.
While holding the right hard button, select the device you'd like to remove the command from.
When prompted, select "Delete Device Action".
If you're using ProntoEdit:
Upload your configuration from the Pronto if you have not done so already.
Double-click on the device name.
Double-click on the "Properties" option.
Under the "Action" tab, delete the [C] UDB command.
Download your setup back to the remote.


This message was edited by Joel Warren on 02/10/02 17:15.41.

OK OK But my excuse is I have a 6000 :) :)

That's no excuse . . . you'd be better off blaming the Emu!

MIKE