| Post 1 made on Friday December 21, 2001 at 10:25 |
BradP Founding Member |
Joined:
Posts: | November 2001
23 |
|
|
I can't seem to figure out how to change the lower 4 hard buttons on the Pronto Pro when the device is in the MACROS area. On a device in the regaular devices area, I can change those hard buttons fine, but in the properties area under Macros, while the right side buttons are remappable, the lower 4 aren't.
Also, does anyone know how those 4 hard buttons behave in a CCF? I was hoping I could set them globally on the CCF and override them where I want to, however, with Daniel's CCF, I see a lot of times they're mapped to "up" and "down" (the left and right buttons anyway) and I can't seem to find where! My global settings from the main properties of the remote don't seem to carry into other areas all the time.
Brad
|
|
| Post 2 made on Friday December 21, 2001 at 10:33 |
Anthony Ultimate Member |
Joined:
Posts: | May 2001
28,798 |
|
|
1) you cannot
2)extreme buttons are normally up down, so if you do nothing they will be that way (at least if you have more then one panel that is not hidden) Do you have the latest version of PPE?
|
... |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
