| Post 1 made on Thursday December 20, 2001 at 16:39 |
Bob Beerens Founding Member |
Joined:
Posts: | December 2001
2 |
|
|
After downloading configuration into Pronto, I can no longer access menu mode to learn codes to Pronto. The menu mode icon does not show up at the bottom of the touch screen. Also, When I go into setup mode, the bar to turn menu mode on and off is not even there, normally it shows the menu mode icon with an x through it. Can anyone help me?
|
|
| Post 2 made on Thursday December 20, 2001 at 17:40 |
John Pechulis Loyal Member |
Joined:
Posts: | July 2001
7,127 |
|
|
Sounds like a corrupt file. Try loading a different file to see if it returns.
JJP
|
|
| Post 3 made on Thursday December 20, 2001 at 17:41 |
In ProntoEdit:
- Go into the System Properties Menu (It’s located under Home).
- Once in the Menu, click on the “Pronto System Properties” Tab.
- Un-click the box labeled: “configuration is write-protected”.
- Hit “Apply” and then click “OK”.
- Re-download your CCF to your Pronto.
|
|
| OP | Post 4 made on Thursday December 20, 2001 at 22:39 |
Bob Beerens Founding Member |
Joined:
Posts: | December 2001
2 |
|
|
Thankyou! That worked. After I changed the write protected box in the system properties the menu mode returned.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
