| Post 1 made on Tuesday December 18, 2001 at 23:08 |
Matt C. Founding Member |
Joined:
Posts: | December 2001
4 |
|
|
the problem that i am having is that after i capture an ir code in setup i can't change the name for good am i missing something? any help would be appreciated.
|
|
| Post 2 made on Tuesday December 18, 2001 at 23:13 |
drhb Founding Member |
Joined:
Posts: | July 2001
519 |
|
|
It is a bug in the software, as in RCEdit, and other software.
Try cutting the ir code and pasting it back in the same place again. The name will stay, if you do this. At least this is the solution I found to work with RCEdit.
Good Luck,
Harris
|
|
| Post 3 made on Tuesday December 18, 2001 at 23:14 |
MrKlaatu Loyal Member |
Joined:
Posts: | May 2001
7,749 |
|
|
B11−10 Why can't I change IR code labels in ProntoEdit 2.0? MIKE
|
|
|
| Post 4 made on Wednesday December 19, 2001 at 00:18 |
Peter Dewildt Loyal Member |
Joined:
Posts: | July 2001
6,307 |
|
|
The name of a code should never be important unless you are learning IR Codes into macros which is not the best way to set up your CCF. Always use aliases in macros.
|
Peter
Pronto 1000 (retired), Pronto TSU7000, RFX6000 (retired)
Pronto 2xTSU9600, RFX9400 |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
