| Post 1 made on Sunday December 16, 2001 at 10:33 |
Harlan Founding Member |
Joined:
Posts: | December 2001
2 |
|
|
Hi,
I have a TS1000 loaded with 1.05v software. I was updating my CCFs this morning and for some reason the icon to shift into the "learn" mode has disappeared from the display. It shows on the emulator but not on the Pronto. Any help?
Many thanks!
HArlan
|
|
| Post 2 made on Sunday December 16, 2001 at 11:57 |
bomberjim Super Member |
Joined:
Posts: | September 2001
3,894 |
|
|
Harlan,
Not exactly sure what you mean by "the icon" If you mean the mode button at the bottom of the screen, it can be turned on or off on the Pronto. Press the remote icon at the top of the Pronto for 2 seconds. On page 2 is the control for the mode button.
Jim L
|
Jim L  |
|
| Post 3 made on Sunday December 16, 2001 at 12:45 |
kabster Founding Member |
Joined:
Posts: | July 2001
1,606 |
|
|
open your ccf in P.E. and look at the home properties .
If configuration is write protected uncheck it.
|
|
| OP | Post 4 made on Tuesday December 18, 2001 at 18:58 |
Harlan Founding Member |
Joined:
Posts: | December 2001
2 |
|
|
Bomberjim,
Thanks! Your advise worked. By the way, my nickname is "thebomber" :-).
HArlan aka thebomber
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
