| Post 1 made on Thursday November 22, 2001 at 01:05 |
Joe Jensen Founding Member |
Joined:
Posts: | August 2001
13 |
|
|
I have a Pronto TS1000. I built my configuration by putting the learned codes on panels under the Macro section and then referencing those learned codes as needed. I have station logo buttons for each station on direct TV. These buttons reference the learned keypad codes for my old RCA directTV receiver. I just purchased a Philips Direct Tivo and I need to find the easiest way to swap the Direct Tivo keypad codes for the old RCA direct TV codes so I don't have to re-code every one of the 200 Direct TV station logo buttons. Is there a way?
BTW, my configuration is posted here, search for Joe Jensen.
Thanks...joe
|
|
| Post 2 made on Thursday November 22, 2001 at 05:47 |
Rufus Founding Member |
Joined:
Posts: | October 2001
133 |
|
|
Joe, wherever you have learned the (ten?) keypad codes, simply re-learn the ten for the Tivo. The references made by the channel buttons will then still work ok, asuming that the channel numbers are still the same.
|
|
| Post 3 made on Thursday November 22, 2001 at 09:24 |
Anthony Ultimate Member |
Joined:
Posts: | May 2001
28,798 |
|
|
1) move the panel from the macro section to the device section and download to the Pronto
2) put the Pronto into learn mode and change to the panel with the codes
3) learn the codes for each key
4) upload back to Pronto
the other way
copy and paste the codes from the Tivo CCF to your CCF but it would probably be longer. But it would be a good way to see if there are discrete codes
|
... |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
