| Post 1 made on Sunday August 5, 2001 at 18:29 |
Hi all,
I have a TSU2000 and am using ProntoEdit 2.0. I have my unit fully programmed (thanks to all the good info here) except for discrete power codes.
According to the FAQ it looks like I should be able to go to the properties of a button, Set IR, View IR (right now it is set to the UDB "Power" code for my device), then copy and paste over whatever code is there with the discrete code. However, I can't paste over this and the window with the code is in gray (usually indicating it can't be edited).
Where am I going wrong here? (where do I go to copy/paste the new hex code in?)
Thanks,
Brian
|
|
| OP | Post 2 made on Sunday August 5, 2001 at 18:35 |
kabster Historic Forum Post |
|
|
look in utilities on this site for pronto ini by Daniel Tonks , use it to enable developer mode
|
|
| OP | Post 3 made on Monday August 6, 2001 at 13:24 |
Andrea Whitlock Historic Forum Post |
|
|
Or read this part of the FAQ (In ProntoEdit v2.0, why can't I edit hex codes?): [Link: remotecentral.com]
|
|
| OP | Post 4 made on Tuesday August 7, 2001 at 09:51 |
dhoude Historic Forum Post |
|
|
thanks, you helped me too.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
