| Post 1 made on Saturday August 4, 2001 at 18:10 |
AndyGB Historic Forum Post |
|
|
I bought myself a Pronto today and having read through the Pronto edit manual, one of the first things I did (apart from having a quick play) was to update the software as it recommended.
It didn't seem to have any problems doing the update but now the remote is dead. If I touch the screen or any hard button nothing appears on screen. I have pressed the reset button but still nothing happens. Does anyone have any ideas ?
This message was edited by AndyGB on 08/04/01 18:34.15.
|
|
| OP | Post 2 made on Monday August 6, 2001 at 17:44 |
Daniel Tonks Historic Forum Post |
|
|
Nothing at all? No beeps, etc? Try leaving the batteries out for at least 8 hours then try again.
|
|
| OP | Post 3 made on Monday August 6, 2001 at 19:11 |
Peter Dewildt Historic Forum Post |
|
|
What firmware did you update it with?
If you have a 2000, do NOT update it with the 1.05 firmware. There is a special program you can download for updating the 2000.
BTW, if you do have a 2000, there was no reason to update it in the first place. The firmware is still the same.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
