| Post 1 made on Tuesday May 1, 2001 at 13:50 |
When programming the buttons to my Philips/Mag. TV, I have some that are referenced by what I term the "RC5 Command #"; i.e.: System 0, Command 1. However, I didn't have all of these numbers, I had to use the UDB for some commands. In the button properties screen, It just shows [C] UDB, whereas the ones I entered manually show [C] RC5 0 1. Is there a way to find the system and command #'s without going manually going through the command #'s to see what they do.
Also, I just got my TSU2000, and thanks to everyone here, especially Dan for all the work, codes and graphics.
|
|
| OP | Post 2 made on Tuesday May 8, 2001 at 01:15 |
Daniel Tonks Historic Forum Post |
|
|
You need to activate 'developer' mode by adding developer=1 to the pronto.ini file. Check the FAQ under B11-08.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
