| Post 1 made on Saturday March 31, 2001 at 11:53 |
I picked up the usa-19w adapter but pronto still won't connect. It installed on to com2. Com1 is open and I have seen where sometimes it is necessary to install on com1 in order for the pronto to see it. But how do you do this?
I am running windows ME on a new toshiba satellite laptop.
The keyspan shows up in device manager and tests ok.
I just have no idea how to change com ports or force something to install on a different com port.
mucho thanks for any advice!
|
|
| OP | Post 2 made on Saturday March 31, 2001 at 13:10 |
CharlesH Historic Forum Post |
|
|
Use the system bios setup program. Usually you would hit during the self test to get into the setup program. Make sure that the I/R port is turned off and check to make sure your modem is not conflicting as well....
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
