| Post 1 made on Wednesday February 14, 2001 at 10:27 |
Using pronto edit 1.5 it will display learned or the rc 5 code when learning a code but when i go to use it it will not work not even if i learn it stand alone straight into the remote but this is only happening to one of my device page . I have used the remote that came with the componet and it works. Have any suggestions THANKS!!
|
|
| OP | Post 2 made on Wednesday February 14, 2001 at 10:37 |
Anthony Historic Forum Post |
|
|
A code has two parts (in general) the initial part and the repeat. If the Pronto has not learnt the initial part correctly your equipment will not be affected by the IR. Try letting a few fraction of seconds pass before you press your button i.e.
1) press button on Pronto
2) breath (if you are using ProntoEdit breath a few times)
3) press and hold button on original remote
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
