| Post 1 made on Thursday February 8, 2001 at 07:56 |
george Historic Forum Post |
|
|
My pronto stopped learning ir codes . It is abt one year old and was working perfectly. Anyone have a clue as to what could be the problem. Yes I did just install the updated versions of pronto edit and the software upgrade.
|
|
| OP | Post 2 made on Thursday February 8, 2001 at 10:24 |
Anthony Historic Forum Post |
|
|
I hate to ask this, but are you sure you are using it the correct way? you point your remote to the back of the Pronto
|
|
| OP | Post 3 made on Thursday February 8, 2001 at 14:05 |
When using ProntEdit and my 2000 stops learning, I use the reset thingy on the bottom and it starts learning again.
|
|
| OP | Post 4 made on Thursday February 8, 2001 at 16:41 |
GTEDENJR Historic Forum Post |
|
|
|
| OP | Post 5 made on Thursday February 8, 2001 at 16:43 |
GTEDENJR Historic Forum Post |
|
|
Sorry Dave that was meant for Anthony.
|
|
| OP | Post 6 made on Thursday February 8, 2001 at 16:53 |
Try "learning" when the unit is NOT connected to ProntoEdit. There have been some threads discussing that doing so is not reliable.
|
|
| OP | Post 7 made on Thursday February 8, 2001 at 17:30 |
GTEDENJR Historic Forum Post |
|
|
I have tried both ways. I have programed this thing 20 times with no difficulties. I downloaded the new pronto edit and the upgrade and now it doesn't work. I even wiped it clean, reinstalled the original programing and reset it. no luck. I think I will send it back to phillips and let them figure it out.
|
|
| OP | Post 8 made on Thursday February 8, 2001 at 17:39 |
jdooley Historic Forum Post |
|
|
If a ccf is set to read only will it then not accept new codes?
|
|
| OP | Post 9 made on Thursday February 8, 2001 at 22:06 |
GTEDENJR Historic Forum Post |
|
|
Thanks for yor comments everyone. I solved the problem.
I went back to my dealer and he gave me a new one. Simple solution to a complex problem.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
