This is a nice remote and am very happy with it except for one thing . I can switch to VCR , DSS , Radio but cannot switch to DVD . The IR learning doesnt pick it up for what ever reason , I have tried the advanced codes , I think 124 Select DVD/LD advanced code is the one I should use it but it doesnt work . Any help would be greatly appreciated .

[Link: remotecentral.com]

I tried everything in that post and when triing to put
0234 or any other code onto audio or aux button it says code not found . I am totally lost here . Going to call Tech Support tommorrow I guess . :( Sorry for posting a thread that has been posted before but most of them are so long that I decided to start a new thread .

This is tape code 0243, you can either change RCVR/AMP into TAPE, then change back later, or use two devices one AMP and one TAPE, my directions are for the former.
1. press RCVR/AMP
2. press and hold SET, the screen changes to CODESET
3. press SELECT
4. scroll down to TAPE
5. press SELECT, since code 0243 is the only tape code there is, no need to enter the code.
6. press EXIT

Now to map the DVD efc:

1. press and hold SET
2. scroll down to KEYMOVER
3. press SELECT
4. press RCVR/AMP
5. press SET
6. enter 124
7. press SELECT
8. press RCVR/AMP
9. pick a key, one not being used.
10 success

Now change the RCVR/AMP back to RCVR/AMP


This message was edited by edmund on 01/13/04 13:20.

OMG . I don't know what I was doing wrong them other times but , I followed what you said and it totally worked , Thnx alot .