| Post 1 made on Thursday September 28, 2006 at 16:42 |
I have a MX-800 w/MRF-200.
Is it possible to lengthen a mini-blaster wire? Can I just cut it and solder another wire in?
If this is possible, would it work 40' long?
Thanks,
Bill
|
|
| Post 2 made on Thursday September 28, 2006 at 16:50 |
Surf Remote Loyal Member |
Joined:
Posts: | July 2001
5,958 |
|
|
You can use Cat. 5 or similar. Use a match to burn off the thin coating of Teflon on the emitter wire before you solder it to another wire. 40' is pretty long, but the 250's output level is high. It should work but it depends on the sensitivity of the IR receiving eye on the other end. Mike www.SurfRemoteControl.com
|
www.SurfRemoteControl.comTHX-certified video calibrator and contributing writer, ProjectorReviews.com |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
