| Post 1 made on Tuesday December 13, 2005 at 10:46 |
Lsteen Lurking Member |
Joined:
Posts: | December 2005
7 |
|
|
I am trying to teach my MX-500 the Comcast On-Demand button command. The MX-500 responds that it has learned the command while programming but does not function? Any Ideas out there?
|
|
| Post 2 made on Tuesday December 13, 2005 at 13:06 |
Tom Ciaramitaro Loyal Member |
Joined:
Posts: | May 2002
7,851 |
|
|
I believe channel 1 may be "on demand" - check by hitting the 1 digit plus enter. You could store a macro with those two commands on your on demand button.
Most of the comcast boxes seem to require an enter command after a single- or double-digit channel number, so you are probably not getting the full command learned.
|
There is no truth anymore. Only assertions. The internet world has no interest in truth, only vindication for preconceived assumptions. |
|
| Post 3 made on Tuesday December 13, 2005 at 14:28 |
You really don't need to program any "on demand" button, since all that content is at channel 1. With the Comcast/Motorola DVR, whether or not you need an enter command after a single digital channel number depends on a changeable setting. In the DVR menus, go to Setup -> Guide -> Auto-tune. The default setting is No. If you change the Auto-tune setting to Yes, you only need to enter the digit 1, and the DVR will automatically imply the enter command and switch to On Demand.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
