| Post 1 made on Monday December 12, 2005 at 06:26 |
The RF commands of my 800 aren't working. When I press a button, the base light flashes several times quickly.
Thanks for any help.
|
|
| Post 2 made on Monday December 12, 2005 at 11:22 |
Surf Remote Loyal Member |
Joined:
Posts: | July 2001
5,958 |
|
|
A little more information would help. Was the RF previously working? Does the remote work in IR mode? Are you using the blaster or the individual emitters? If you're using the blaster, do you have the MRF-200 on an ID other than "0" (which it should be regardless)? Mike www.SurfRemoteControl.com
|
www.SurfRemoteControl.comTHX-certified video calibrator and contributing writer, ProjectorReviews.com |
|
| OP | Post 3 made on Monday December 12, 2005 at 11:30 |
Sorry ... I used to check these boards often and thought I remembered this being a standard problem with a standard solution. I couldn't find it with a search.
Yes, the remote was previously working. It does work on IR. It's not on ID 0. I only want to control 2 devices via RF; they're set to Lines 1 and 2.
Thanks again.
|
|
| Post 4 made on Monday December 12, 2005 at 12:47 |
Surf Remote Loyal Member |
Joined:
Posts: | July 2001
5,958 |
|
|
Your MRF may have given up the ghost. Try a different receiver ID first, but then give URC a call at 800-901-0800 and see if they can help.
|
www.SurfRemoteControl.comTHX-certified video calibrator and contributing writer, ProjectorReviews.com |
|
| OP | Post 5 made on Monday December 12, 2005 at 13:58 |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
