| Post 1 made on Saturday April 23, 2005 at 00:52 |
I can't get RF to work. Status light flashes constantly.I have tried to program RF only,RF/IR and flasher1. I am also looking for code for satellite reciever "Dish Network 2701 "
|
|
| Post 2 made on Saturday April 23, 2005 at 09:47 |
hiker Long Time Member |
Joined:
Posts: | January 2005
440 |
|
|
Is the dial on the bottom of the MRF-200 set to "0"? That setting is only for testing...if the light is blinking then you are receiving interference and will probably get erratic operation thru RF. Change the dial to another number and update the ID to the same number in RF Setup in MX-Editor and try again. Also while the dial is set to "0", try moving the MRF-200 to different location to see if the blinking stops.
For the 2701, try the generic 122 [DISH NETWORK 1] pre-programmed set.
This message was edited by hiker on 04/23/05 09:57 ET.
|
|
| Post 3 made on Saturday April 23, 2005 at 12:56 |
justarep Long Time Member |
Joined:
Posts: | April 2005
252 |
|
|
On the bottom of the RF base there is a sticker with a version number. What does that say?
|
|
| OP | Post 4 made on Saturday April 23, 2005 at 13:11 |
Thanks. I have wireless router with same channel which was causing interfearence.
Generic code works for few buttons. I can't get channel up anad down. For now I have programmed manually by learn code.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
