| Post 1 made on Friday April 22, 2005 at 16:38 |
frink Long Time Member |
Joined:
Posts: | November 2003
16 |
|
|
I am having some problems with an installation of an Mx3000 and mrf250.
The issue is basically some functions that are programmed work fine with a
physical button tap on the unit's screen but have intermittant function when
placed in a macro. The two units that seem the most problematic are a Harman Kardon
Avr 235 receiver and some x-10 lights. I have tried adjusting the number of
ir repeats but that has not helped the problem. Any advice on solving this would be great. Thanks in advance.
|
|
| OP | Post 2 made on Friday April 22, 2005 at 17:32 |
frink Long Time Member |
Joined:
Posts: | November 2003
16 |
|
|
I guess I should also add there are delays(.1 and .2 secs) before and after the x10 command and the input select command on the receiver is the first item in the macro.
|
|
| Post 3 made on Friday April 22, 2005 at 18:50 |
Glackowitz RC Moderator |
Joined:
Posts: | May 2002
3,784 |
|
|
Try making the delays a bit longer, say .3-.5 sometimes the IR overlaps just a bit and could be causing what you are experiencing.
Glack
|
There's no worse feeling than that millisecond you're sure you are going to die after leaning your chair back a little too far. |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
