| Post 1 made on Sunday March 13, 2005 at 12:33 |
Can anyone assist me with configuring my mx700 to control the Dish Network 811? I have created the device, selected the Dish 811 (IRC 122), however, my receiver does not respond. I have downloaded another member's 811.mxd and imported it, to no avail. I have used the 811's teach remote feature, which is supposed to receive a rf signal and bounce it back to the mx700 as an ir command (learning mode), to no avail.
Any advice would be appreciated.
|
|
| Post 2 made on Sunday March 13, 2005 at 12:46 |
Surf Remote Loyal Member |
Joined:
Posts: | July 2001
5,958 |
|
|
|
| OP | Post 3 made on Sunday March 13, 2005 at 12:57 |
that did the trick, thanks a million Mike...
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
