| Post 1 made on Saturday June 12, 2004 at 23:22 |
jazzman Founding Member |
Joined:
Posts: | December 2001
365 |
|
|
I have a fully charged MX3000 with a single vertical line going down the screen slightly off center horizontal. Yesterday I was able to download and view all of the themes provided but today it's just a vertical "etch a sketch" dark line on an otherwise gray screen. I've tried the battery disconnect thing...is there a reboot procedure? It was in it's cradle charging all day and then went back into it's box last night.
|
|
| Post 2 made on Sunday June 13, 2004 at 00:07 |
Sam1Cohen Founding Member |
Joined:
Posts: | April 2002
110 |
|
|
You can do a full restore to factory settings if you go to the set up page (hold MAIN for a few secs). Make sure you have a backup on your computer. This will put it back to the default settings from the factory, then you can upload again.
Good luck
|
|
| OP | Post 3 made on Sunday June 13, 2004 at 02:16 |
jazzman Founding Member |
Joined:
Posts: | December 2001
365 |
|
|
There ain't no set up page
|
|
| Post 4 made on Sunday June 13, 2004 at 10:00 |
Sam1Cohen Founding Member |
Joined:
Posts: | April 2002
110 |
|
|
There is a set up page, press the main button once, hten press and hold for a few secs (5 I believe) and this will get you to the system set up on the remote. From there you can restore to factory defaults.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
