| Post 1 made on Sunday June 6, 2004 at 14:12 |
I'm confused, I'm sure. If I load the default MX-800 configuration (the one with 20 devices), I can access Main Page 2 by pressing the Page key. However, if load my custom configuration with about 13 devices, I can't get to page 2 to view the rest of them. They are there in MX-800 simulator, but not after I download. I am using the latest firmware and software. I loaded the same config into an MX-700 and it's the same problem. These remotes, I'm sure, are working fine. I'm leaning toward "operator error" on this one, but sure would like to know what I'm doing wrong.
|
|
| OP | Post 2 made on Sunday June 6, 2004 at 14:18 |
Problem solved. Of all things, the page was hidden. As we say in technical lingo - DUH! I knew after puzzling over this for an hour I'd finally figure it out right after I asked the question.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
