| Post 1 made on Wednesday December 18, 2002 at 21:57 |
Advance The Man Lurking Member |
Joined:
Posts: | December 2002
5 |
|
|
Now I am not bitchin, I am sure it's me. I have a Com 1 port, plugged it in, made some edits in MX Editor and tried to download and I get...
"Error detected while communicating with your Remote Control.
Please make sure that the cable from the PC is connect to the Remote Control.
Selections -- Abort Retry Cancel"
I've searched the HTM site and here and no luck. Suggestions?
|
|
| Post 2 made on Wednesday December 18, 2002 at 22:44 |
Rick_Wilson Long Time Member |
Joined:
Posts: | September 2002
368 |
|
|
Are you sure the cable is plugged into the remote until it clicks? I had trouble the first time I connected my 700 because I assumed the cable plugged into it until I felt resistance. However, I found out that the plug went in further and clicked. No problems after that.
|
|
| Post 3 made on Thursday December 19, 2002 at 00:24 |
MikeSRC Loyal Member |
Joined:
Posts: | July 2001
5,958 |
|
|
Also, make sure that nothing else is using the COM1 port. If you have anything else that might be, switch to COM2 and try it. Palm Desktop is the worst offender. Mike www.surfremotecontrol.com
|
www.SurfRemoteControl.comTHX-certified video calibrator and contributing writer, ProjectorReviews.com |
|
| OP | Post 4 made on Thursday December 19, 2002 at 08:49 |
Advance The Man Lurking Member |
Joined:
Posts: | December 2002
5 |
|
|
Thanks, it was the Palm Software.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.
