Your Universal Remote Control Center
RemoteCentral.com
Philips iPronto Forum - View Post
Previous section Next section Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Topic:
more than 2 NetX per panel?
This thread has 4 replies. Displaying all posts.
Post 1 made on Monday February 12, 2007 at 15:07
SirKalle
Long Time Member
Joined:
Posts:
January 2003
130
Hi guys,

is it possible to use more than 2 NetX per Panel? If I use iPronto edit and select a panel, then go to the RF rider and then AUTO DETECT NetX - I see two well configured NetXs but I only can select one?

Does anyone know a method how to select more than one?

Thanks!

Best regards,

Kalle
Post 2 made on Friday February 23, 2007 at 10:31
JoeyCes
One In A Million
Joined:
Posts:
May 2004
1,329
I had one iPronto control FOUR netX's, in a conference room environment, all on WIFI, worked well, only downfall, ITS 802.11B, so its not that strong...
OP | Post 3 made on Sunday February 25, 2007 at 12:44
SirKalle
Long Time Member
Joined:
Posts:
January 2003
130
@Joey:

Yes, the NetX babys work fine. BUT:

Can I use BOTH of them in the SAME panel? I can only select ONE in iPronto Edit per panel, not TWO!

Well, I think this is a "feature" :-)

Best regards,

Kalle
Post 4 made on Monday February 26, 2007 at 08:33
JoeyCes
One In A Million
Joined:
Posts:
May 2004
1,329
From past knowledge, you address each Netx with an iP address, and also a device name, when you open the panel options, you should see ALL available NetX's, you should have named each one different, NetX_Rack, NetX_Desk, NetX_Shades, and so on, then you can address each one in your programming, i have not had any issues in an evironment such as this, the example was from an actual program i wrote about 6 Months ago, each NetX was addressed differently, and IR codes were routed to each NetX correctly, ALL FOUR showed up on the panel, no issues.
OP | Post 5 made on Friday March 2, 2007 at 13:54
SirKalle
Long Time Member
Joined:
Posts:
January 2003
130
How did you seperate them? With a comma?

Fascinating!

It didn't work. Well, maybe I am to dumb to use iPronto Edit!? :-)


Best regards,

Kalle


Jump to


Protected Feature Before you can reply to a message...
You must first register for a Remote Central user account - it's fast and free! Or, if you already have an account, please login now.

Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace. For information on how to advertise your service or product click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.

Hosting Services by ipHouse